Changing DIP switches
DIP (Dual In-line Package) switches consist of a bank of 8 switches in a small plastic block mounted on the surface of a board. DIP switches either slide or rock to the on or off position.
CHANGING DIP SWITCHES:
1) Locate the DIP switch(s) on the board (refer to diagram in manual if necessary).
2) Determine current DIP switch setting and record it on paper (to return to later if necessary).
3) Refer to table or diagram in manual to determine required setting for the new situation. Write new setting down for clarity.
4) Using a pen tip or small screwdriver, slide or flip the switch to be changed. Move it towards 'ON' to turn in on; away from 'ON' to turn it off.
5) Repeat Step 4 for each additional switch that requires changing.